The City of Calgary Land Use Bylaw 1P2007
Top of page
PART 11: CENTRE CITY DISTRICTS
Division 4: General Rules for Centre City Commercial Land Use Districts
Projections into Setback Areas
1146
1
Unless otherwise referenced in this section, a building must not be located in any setback area.
2
Portions of a building located above the surface of the ground may project into a setback area only in accordance with the rules contained in this section.
3
Portions of a building below the surface of the ground may extend without any limits into a setback area.
5
Eaves may project a maximum of 0.6 metres, and window wells may project a maximum of 0.8 metres, into any setback area.
6
Landings not exceeding 2.5 square metres, ramps other than wheelchair ramps and unenclosed stairs may project into any setback area.
7
Signs may be located in any setback area, and where so located must be in accordance with Part 3, Division 5.
General Landscaped Area Rules
1147
1
Landscaped areas must be provided in accordance with a landscape plan approved by the Development Authority.
2
A landscape plan for the entire development must be submitted as part of each development permit application where changes are proposed to the building or parcel, and must show at least the following:
c
the layout of berms, open space systems, pedestrian circulation, retaining walls, screening, slope of the land, soft surfaced landscaped areas and hard surfaced landscaped areas;
3
The landscaped areas shown on the landscape plan approved by the Development Authority must be maintained on the parcel for so long as the development exists.
4
All soft surfaced landscaped areas must be irrigated by an underground irrigation system, unless a low water irrigation system is provided.
5
For the purpose of determining the minimum number of trees and shrubs in a setback area, portions of setback areas that are paved for sidewalks and vehicle access, utility rights of way, or any other purpose allowed by the Development Authority must be included in the calculation of the required area even though they are not capable of sustaining trees and shrubs.
6
If the minimum setback area is not capable of sustaining trees and shrubs, additional area on the parcel located adjoining the setback area must be provided for the trees and shrubs.
Planting Requirements
3
Deciduous trees must have a minimum calliper of 50 millimetres and at least 50.0 per cent of the provided deciduous trees must have a minimum calliper of 75 millimetres at the time of planting.
4
Coniferous trees must have a minimum height of 2.0 metres andat least 50.0 per cent of the provided coniferous trees must have a minimum of 3.0 metres in height at the time of planting.
Low Water Irrigation System
1149
1
When a low water irrigation system is provided, only trees and shrubs must be irrigated and the extent of water delivery must be confined to the tree and shrub area.
2
When a low water irrigation system is provided, trees and shrubs that have similar water consumption requirements must be grouped together.
Additional Landscaping Requirements
1150
1
Unless otherwise referenced in a District, all setback areas on a parcel, not including those portions specifically required for motor vehicle access, sidewalks, or any other purpose allowed by the Development Authority, must be a landscaped area.
2
All areas of a parcel must be a landscaped area unless specifically allowed by the Development Authority.
3
Every building on a parcel must have at least one sidewalk connecting the public entrance to a public sidewalk, or in the case where there is no public sidewalk, to the nearest street.
4
Where a building contains more than one use, every use that has an exterior public entrance must either:
5
Every building on a parcel must have at least one sidewalk connecting the parking area to the public entrances of the building.
Residential Amenity Space
1151
1
A patio may be located in a setback area between a multi-residential building and a property line shared with a street.
2
Amenity space may be provided as common amenity space, private amenity space or a combination of both.
4
When the private amenity space provided is 5.0 square metres or less per unit, that specific area will be included to satisfy the amenity space requirement.
5
When the private amenity space exceeds 5.0 square metres per unit, only 5.0 square metres per unit must be included to satisfy the amenity space requirement.
c
must have a contiguous area of not less than 50.0 square metres with no dimension less than 6.0 metres;
9
A maximum of 50.0 per cent of the required amenity space may be provided as common amenity space — indoors.
b
must be used in the calculation of the required landscaped area when located below 25 metres above grade.
Visibility Setback
1152
Buildings, finished grade of a parcel and vegetation within a corner visibility triangle must not be located between 0.75 metres and 4.6 metres above the lowest elevation of the street.
Mechanical Screening
1153
Mechanical systems or equipment located outside of a building shall be positioned, camouflaged or screened from view of a public space, or from view of a parcel designated as a residential district, located within 30.0 metres of the equipment, using a line of sight of 1.7 metres above grade.
Recycling Facilities
1155
Recycling facilities must be provided for every building containing Dwelling Units or Office uses.
Screening
1156
When a parcel shares a property line with a lane, or a parcel designated as a residential district, a fence with a maximum height of 2.0 metres must be provided for screening along the property line.
Motor Vehicle Parking Stall Requirements
1157
1
For developments containing Dwelling Units or Live Work Units, the minimum motor vehicle parking stall requirement:
Exclusive Use of Bicycle Parking Stalls
1160
Bicycle parking stalls — class 1 provided for Dwelling Units and Live Work Units are for the exclusive use of residents.
Parcel Access
1161
All developments must comply with the access requirements of the Controlled Streets Bylaw.